This kit includes everything you need to upgrade an existing Duosida connector with the Tesla button. The kit can be used for all cables and fixed charging station pigtails that have a Duosida (Dostar) connector with a 16 or 18mm rear end opening as depicted in the photo. Make your choice of a 16A or 32A kit. It is VERY important to use the correct kit, since a 32A connector on a 16A cable can overheat the cable, while a 16A connector on a 32A cable will only allow charging at 16A...
The Patent Pending design of the EVChargeKing connector allows the integration of the Tesla command button in the housing in such a way that it can be re-opened and serviced, while remaining 100% waterproof. All necessary electrical requirements for the cable are present in the electronics, so all you need to do is cut the existing resistor from the small cable going from PE to PP inside the connector, solder on the kit's button, install the new housing and button, and you are good to go!
The connector can be used for single and 3-phase cable assemblies.
For full installation instructions, click here